The microphone is fairly sturdy, weighing just under 1.5 pounds (670g). This makes it about half a pound lighter than the Rode PodMic USB (1.9lbs / 900g) and a quarter of a pound heavier than the HyperX FlipCast (1.26lbs / 571.5g).
In the box, the Seiren V3 Pro comes with a flat, round desktop stand and a 10-foot (3m) braided USB-C to USB-A cable with a USB-A to USB-C adapter attached.
(Image credit: Tom's Hardware) (Image credit: Tom's Hardware) The stand measures approximately 4.75 inches (120mm) in diameter and weighs just over 7 ounces (200.5g). It's also made of metal, with a matte black finish and a 5/8"-threaded mount in the center. The bottom is covered in soft non-slip rubber with five small rounded, raised "feet" (for better shock absorption, I assume). The stand is sturdy and stable and attaches securely to the mic; the only caveat is that it does end up sitting quite low on your desk. This isn't too much of an issue, as the mic is fairly tall, but since it's also pretty quiet — even with the gain turned all the way up — mounting it on a boom arm is probably the best option.
The Seiren V3 Pro is an end-address dynamic capsule microphone with a cardioid polar pattern and both USB-C and XLR connectivity. It features a large 30mm capsule with an integrated shock absorber and a built-in advanced audio DSP. It records audio in 32-bit / 96 kHz resolution and it also supports 32-bit float through Razer's Synapse software. It has a frequency response rate of 50 – 16,000 Hz and an adjustable gain of 40dB.
My voice sounded pretty good over the Seiren V3 Pro with its out-of-the-box settings: Full, warm, and clear, though there was definitely some sibilance. The foam pop filter did a decent job of keeping plosives at bay, though it had some trouble as I moved closer to the mic (as you might expect). People I talked to over voice chat thought I sounded about the same as usual — like I had a solid, studio-quality end-address mic, but they didn't think it stood out against the other studio-quality end-address mics they normally hear my voice over.
(Image credit: Tom's Hardware) (Image credit: Tom's Hardware) The on-mic controls were decent — the tap-to-mute button worked flawlessly, muting and unmuting with just a light brush of my finger. Both the button and the light ring turn red when the mic is muted, so you have a decent visual cue when your audience can't hear you. The gain control wheel, which has a textured metal surface, is smooth and easy to roll even if it's a bit awkwardly placed on the back / bottom of the mic.
I did find that this mic was relatively quiet, even with the gain turned up all the way — it wasn't too quiet, but I found myself needing to speak louder than I did with other mics. This seemed to be due, in part, to the mic's off-axis rejection — which Razer boasts is "enhanced" to better suppress ambient noise and room reflections without relying on processing. The off-axis rejection definitely did seem to be enhanced, as very little of the ambient noise in my room was picked up (even when I had the AI noise suppression turned off). But it also meant that if I moved out of line with the mic, it was much harder to hear me. This is definitely expected behavior from an end-address mic, but the Seiren V3 Pro was a little less flexible than, say, the HyperX FlipCast. Just a little, though.
The Seiren V3 Pro is configurable via Razer's Synapse peripheral software. The mic has an on-mic gain control wheel that can be configured in Synapse to control headset volume instead, but that's the only on-mic control aside from the tap-to-mute button. For everything else, you'll need Synapse.
While Razer says the Seiren V3 Pro is designed to work without needing software, there's actually a lot in Synapse that you'll probably want to take advantage of with this mic. There's a parametric EQ with a handful of presets ("Podcast," "Arena," "FPS – Callout," and "Studio"), as well as EQ effects such as a De-Esser, Vocal Bass, Vocal Exciter, and a High Pass Filter.
(Image credit: Tom's Hardware) (Image credit: Tom's Hardware) There are also several other effects you can play around with, including the AI noise suppression and a noise gate (plus a compressor, a limiter, and reverb control). The AI noise suppression did a good job of suppressing some noise without too much processing or losing my voice, but it also didn't suppress that much noise. The noise gate worked a little better at suppressing noise, but it also ended up suppressing my voice, even on low settings.
Razer also includes a Stream Mixer, which is essentially a virtual mixing device for mixing various audio channels on your PC — stream, playback, headphone, and mic. I didn't have much time to play around with this, but it seems about as user-friendly as a virtual mixer can be (that is… not very, but what can you do).
You can also customize the Seiren V3 Pro's light ring with Synapse — you can either use one of Razer's preset "quick effects" or you can set up advanced effects in Razer's Chroma app (which is part of Synapse… sort of?). The light ring has 12 independent RGB zones.
The Seiren V3 Pro is a sturdy, sleek-looking end-address mic aimed at creators of all kinds — whether you're just starting streaming or you've got millions of people tuning in each day. Its dual-connectivity means that you'll be able to use it with both your PC and a dedicated audio interface, and the 32-bit float support is a nice touch if almost certainly not necessary for the majority of the audience.
However, this mic isn't exactly revolutionary, especially at its $250 price point. The HyperX FlipCast is very similar — it even has a light ring and a Shure-inspired chassis — but it has much better on-mic controls. The Rode PodMic USB has no on-mic controls, but you can't beat the quality of the PodMic's proximity effect. I was impressed with the extra features this mic has in Synapse, but software-based enhancements (especially when the software is Synapse) are just a bonus, not the foundation.
Sarah Jacobsson Purewal is a senior editor at Tom's Hardware covering peripherals, software, and custom builds. You can find more of her work in PCWorld, Macworld, TechHive, CNET, Gizmodo, Tom's Guide, PC Gamer, Men's Health, Men's Fitness, SHAPE, Cosmopolitan, and just about everywhere else. ","collapsible":{"enabled":true,"maxHeight":250,"readMoreText":"Read more","readLessText":"Read less"}}), "https://slice.vanilla.futurecdn.net/13-4-24/js/authorBio.js"); } else { console.error('%c FTE ','background: #9306F9; color: #ffffff','no lazy slice hydration function available'); } Sarah Jacobsson Purewal Social Links Navigation Senior Editor, Peripherals Sarah Jacobsson Purewal is a senior editor at Tom's Hardware covering peripherals, software, and custom builds. You can find more of her work in PCWorld, Macworld, TechHive, CNET, Gizmodo, Tom's Guide, PC Gamer, Men's Health, Men's Fitness, SHAPE, Cosmopolitan, and just about everywhere else.
Key considerations
- Investor positioning can change fast
- Volatility remains possible near catalysts
- Macro rates and liquidity can dominate flows
Reference reading
- https://www.tomshardware.com/peripherals/microphones/SPONSORED_LINK_URL
- https://www.tomshardware.com/peripherals/microphones/razer-seiren-v3-pro-review#main
- https://www.tomshardware.com
- NVIDIA Confidential Computing to Help Expand Apple’s Private Cloud Compute
- Grab an $800 saving on this RTX 5070 Ti gaming laptop from HP with customizable specs and a 20-core CPU — base model costs just $1,999 for 16-inch rig with 16GB
- AMD B650 expansion cards hit retail starting at $199 — add four M.2 PCIe 4.0 slots and 11 USB ports to any PC with a PCIe slot
- RetroPad is a ‘full-feature-parity version of Notepad from XP’ in just 2,749 bytes — x86 assembly coded apps comes from Windows legend Dave W Plummer
- NVIDIA Confidential Computing to Help Expand Apple’s Private Cloud Compute
Informational only. No financial advice. Do your own research.