When you purchase through links on our site, we may earn an affiliate commission. Here’s how it works .
The INDX toolchanger promises multi-material printing without the headache of prime towers and massive purge waste. Since toolchangers have a dedicated nozzle for each filament path, they don’t need to clean out the nozzle between color or material swaps; however, they do need to “prime” the nozzle to make sure the filament is flowing at the right pressure. Before the INDX, this meant printing a smallish, unavoidable prime tower. The INDX has been precisely tuned to purge only tiny crumbs of waste into an internal tray, then wipe the nozzle on a silicone pad.
The INDX, invented and patented by Bondtech , uses an induction heater to rapidly bring each nozzle to temperature in a few seconds. This allows the Prusa Core One with INDX to have some of the fastest color swap times we’ve seen.
Tom’s Hardware was sent an eight-tool kit so we could share our first-hand experience with the INDX. It took the better part of a weekend to strip down our existing CORE One and modify it. This involved completely removing the Nextruder, replacing it with the INDX carriage, then mounting a rack to hold the eight tool heads. Eight spool holders were mounted on the sides, using preexisting screw holes. A calibration sensor was mounted to the front corner of the build platform, and an internal waste catcher was installed.
Prusa requested that we not conduct a full review of the Founder’s Edition, as it is merely a taste of what’s to come. The final retail INDX will be a more refined version, with a few tweaks (like better visibility through the front grill) and firmware upgrades. Prusa Research is taking feedback from Founders to improve the retail launch.
Prusa Research goes full spectrum in anticipation of INDX
Key considerations
- Investor positioning can change fast
- Volatility remains possible near catalysts
- Macro rates and liquidity can dominate flows
Reference reading
- https://www.tomshardware.com/3d-printing/SPONSORED_LINK_URL
- https://www.tomshardware.com/3d-printing/prusa-research-founder-edition-indx-launches-limited-1-000-unit-run-of-revolutionary-toolchanger-mod-now-shipping#main
- https://www.tomshardware.com/subscription
- NVIDIA and Hugging Face Bring New Models and Frameworks to LeRobot for the Open Robotics Community
- 'PCIe Gen7 development has already started,' says Silicon Motion's Alex Chou — Nvidia's Storage Next initiative is becoming a focal point
- AMD Ryzen 7 7700X3D review: A slower 7800X3D, but not necessarily a cheaper one
- Tower Semiconductor revives shuttered Panasonic-era fab in $3 billion Japan photonics expansion — METI-backed plan targets $3.6 billion revenue by 2028
- Developer successfully ports Linux to 1994 Sega 32X — Genesis and MegaDrive expansion runs open-source OS on paltry 23MHz processors and 256KB of RAM
Informational only. No financial advice. Do your own research.